Loading...

Mounting Your Tags: Rivets, Screws or Zip Ties

Every TagTuf tag has four mounting holes, two at each end. Rivets, screws and zip ties all work. Here's how to choose, and where to put the tag so it lasts and gets scanned.
Rivets, Screws or Zip Ties
Rivets: the most permanent option, and the hardest for anyone to remove. Good for metal housings, frames and panels.

Screws: good for plastic or wood, or anywhere you may want to move the tag later.

Zip ties: for handles, tubing, frames and hoses, or anything you can't or don't want to drill. Use outdoor-rated, UV-resistant ties, and pull them tight so the tag can't spin or flap.
Four mounting holes, two at each end
Where to Put the Tag
Pick a flat spot where a phone can get close to the QR code without moving the equipment.

Use the same spot on every unit of the same model, so crews know where to look.

Avoid spots that get scraped, kicked or stacked against, and don't cover vents, labels, serial number plates or controls.
A tag with rivets
Before You Drill
Check what's behind the spot: wiring, tanks, coils or anything else a drill bit or rivet could reach. Drilling into some equipment can affect its warranty, so check with the manufacturer if you're not sure, or use zip ties instead.
After It's Mounted
Scan the tag once to make sure it reads, then activate it (or, if it's already active, give it a name and filters) so it's ready the first time a crew scans it.
A riveted tag on equipment that gets washed down
Share:

Comments

No Comments Yet
  0–0 of 0

Post a Comment

If you are human, DO NOT fill in this field: